There are many ways to cut glass bottles (waste light bulbs). Here are a few methods.
Use a glass knife or wind file to make a file mark on the cutting area of the glass bottle, then wrap a cotton thread around the file mark a few times, then drop some alcohol, light the cotton thread for about a minute, and add a few drops of water to the file mark. It can be broken along the file marks.
Cut the waste newspaper into long strips of 5mm-7mm width, then soak the paper strips in clean water and take them out. Wrap the soaked paper strips 1-4 times along the cutting line of the glass bottle and close to the bottle wall. Newspaper The edges must be neat. Light the alcohol lamp, align the cutting line of the bottle with the flame of the alcohol lamp, and keep turning the bottle. After the bottle is hot, place it in cold water to disconnect.
Fill the glass bottle with cooking oil up to the cutting line (leaving a margin for the iron rod), then insert the red iron rod into the oil, and the glass bottle will break along the oil surface.
You can also use a homemade resistance wire cutter to cut glass bottles, glass tubes, light bulbs, etc. When cutting, please pay attention to: First, leave a 1mm-2mm space at the junction of the resistance wire around a circle to avoid short circuit. Second, the glass bottle must be cut off quickly after dripping water. electricity
