Process molten glass into products of fixed geometry. When the glass cools down, it changes from a liquid state, a plastic state to a solid state, and connects the production stages of glass supply and retrieval, shaping and shaping. The viscosity of the molten glass is usually 102.2Pa·s when picking materials manually; it is 102-103Pa·s when feeding automatically by machinery, which is equivalent to 10-100 times the viscosity of the molten glass when it is clarified. The suitable viscosity of the glass drop into the mold is usually 103.5Pa·s, and the viscosity should be 106Pa·s when demoulding. Within this plastic range, the glass frit should be sheared, bonded, blown, and calendered. If the production time is long, the glass composition must be adjusted to slow down the viscosity transition and reduce the crystallization tendency, so as to avoid too fast hardening and crystallization during the molding process. Commonly used glass forming methods include blowing method, pressing method, drawing method, casting method, calendering method and so on.
Glass tube blowing method: used to make hollow glass products, such as water cups, utensils, bottles, cans, light bulbs, etc. A hollow iron blowpipe about 1.5m long is used for manual blowing, one end is dipped in glass liquid (picking material), and the other end is a blowing nozzle. After picking the material, roll it evenly on the rolling plate (bowl), blow air to form a glass bubble, and blow it into a product in the mold; it can also be blown freely without a mold, and then knocked off from the blowpipe. When forming large-scale products, it is necessary to pick and roll the material repeatedly to collect enough material. During mechanical blowing, the molten glass flows out from the outlet of the glass melting furnace, and forms gobs with a set weight and shape through the feeder, which are cut into the primary mold to be blown or pressed into the primary mold, and then transferred to the forming mold to be blown. products. Blowing into the initial shape and then blowing into products is called blowing-blowing method, which is suitable for making small-mouthed utensils and bottles. The pressure-blowing method of pressing into a preliminary shape and then blowing into a product is suitable for making large-mouthed utensils and thin-walled bottles and cans.
