How To Cut Thin Glass Tube Rod Easily

Feb 21, 2022 Leave a message

How to cut thin glass tube rod easily

Cutting of fine glass tube and rod. Under 5 mm - 10 mm in diameter of fine glass tube, rod, when cutting, first of all, on the edge of a table, with a triangular file, grinding wheel piece (or new break bowls) of the blade edges vertical compression in the glass tube to truncate, forcibly push forward, to file mark tube after a third or a quarter of the circumference, picked up the glass tube (rod), the hands hold onto the file marks on the back of the thumb. Other fingers hold the glass tube (rod), both hands at the same time slightly push back to break.


Cutting of thick glass tube. The first will be truncated with a file to file a circle of fine marks, with resistance wire along the fine marks around a week, resistance wire crossing with heat-resistant insulation material separated (or leave 1mm-2mm small seam), resistance wire can be taken from 150W electric furnace wire, heating and straighten. Resistance wire can be adjusted by voltage regulator or low voltage supply to very low voltage power supply. Wait until the resistance wire is red hot for about one minute. Drop a drop of cold water on the mark, and at the same time power off, the glass tube will be disconnected along the mark.


Disconnected glass tube mouth is very sharp, easy to scratch the appearance, so the glass disconnected to do a treatment. The method can be put on the alcohol lamp burning smooth; Second, it can be ground flat on fine emery cloth or grindstone.