1. For all newly purchased edging machines, be sure to read the instruction manual before use. After clarifying the transmission principle of the machine, the role of various handles, handwheels, electrical buttons, water and gas regulating valves, and mastering the maintenance knowledge of the machine, it can be operated on the machine.
2. The quality of the grinding head of the edging machine has a great influence on the grinding quality of the glass. The position and movement clearance of the grinding head have been adjusted at the factory. Except for advancing and retreating the grinding head, the rest should not be moved. , So as not to affect the grinding quality. In addition, the backward position of the grinding head is not easy to be too large, otherwise it is easy to damage the waterproof sleeve, causing water leakage, and it is easy to burn out the motor.
3. Adequate cooling also has a greater impact on the grinding effect. Always check the cooling circuit for blockages. In particular, the pipeline of the linear edging machine is easily blocked by the bristles, and it is not easy to be noticed after the blocking, which will cause insufficient cooling and affect the quality of the edging.
4. The stepless transmission used by the edging machine must be in the open state when adjusting the speed, otherwise it is easy to damage the stepless transmission of the edging machine.
5. Precautions for the use of special-shaped machine: ① Whether the height of the suction cup of the special-shaped machine is consistent has a great influence on the grinding effect. During assembly, the manufacturers have self-polished the five sets of suction cup seats, and have selected the same thickness of suction cup glue to keep the height of each suction cup consistent. Therefore, under normal circumstances, do not disassemble the suction cup. If the suction cup glue is damaged, it should be replaced with the same thickness. ② After the vacuum pump of the special-shaped machine is used for a period of time, the vacuum will drop due to water inflow and other reasons. Therefore, it is necessary to check and eliminate the failure. Otherwise, the machine will work under insufficient suction, which will affect the grinding. Cutting quality is also prone to safety accidents.
6. Precautions for the use of linear edging machine: The working method of linear edging machine (straight edge machine, round edge machine, bevel edge machine) is to grind the glass by clamping the glass with the front and rear pressing plates and driving its linear motion. There are two points that must be noted during use: ① The joint surface of the front and rear pressure plates and the guide rail should be lubricated frequently, otherwise the normal service life of the machine will be affected due to the premature wear of the front and rear pressure plates and the working surface of the guide rail. Some models have automatic lubricating devices, but it is also necessary to check whether the lubricating pipeline is smooth; ② The clamping force should be appropriate when clamping the glass, too loose will affect the grinding quality, too tight will increase the load of the machine, and it is easy to produce Shaking and crawling phenomenon, it is easy to crush the glass when grinding thin glass. The clamping force can be tested on the machine with a slightly larger glass clamp, that is, the glass is clamped in the middle of the machine, and the glass is moved with both hands when the machine is stopped. It feels appropriate to adjust the clamping force to just when the hands cannot be moved.
7. Precautions when using the master: ① The master of the touch machine has a great influence on the grinding accuracy. The working surface relying on the template must be accurate in shape and size, and high in finish. If it is shaped by a template, the transition must be smooth. ② When replacing the template and the suction cup, be sure to keep the level of the working surface of the suction cup, otherwise it will affect the grinding quality.
8. Precautions when using the double-sided edging machine: ① The double-sided edging machine is a higher-grade edging machine. It is best to fix two or three people to ensure correct operation. ② When there are errors or failures in the bilateral grinding program, it is best to ask the original manufacturer to send someone to repair and debug. Under normal circumstances, do not disassemble and repair, so as not to mess up the program and cause the production to stop.